PileTips.com - pile accessories pile points pile tips pile splicers pipe splices for h piles sheet piles pipe piles

:: Home ::

• Inside Fit
• Interchangeable Tips

Open End Cutting Shoes

• Inside-Fit
• Outside-Fit

Steel Pipe Splicers

Chill/Weld Rings

Sheet Pile Drive Points

Timber Pile Points

H-Pile Splicer

VS400 Series H-Pile Splicer

H-Pile splicers save time during driving of long piles by eliminating the need for a full penweld. Made in ASTM A572GR50 or higher strength if requested.

	Welding Procedure Full welding procedure (.pdf)
	1.	Cut 1.0” wide x 1.0" long notch in center of web of one pile.
	2.	Chamfer outside edges of flanges on ends of one or both piles to be spliced. Make chamfer to about ½ material thickness.
	3.	Insert splicer on first pile making sure bolt is completely inside notch.
	4.	Install next section of pile and tighten bolt.
	5.	Using a 70xx series rod, weld the flanges of splicer to the flanges of the pile with (TABLE)” by 3” vertical fillets.
	6	Weld the outside flanges of the piles to complete.