pile accessories h-pile tips h pile points pile splicers pipe splices for h piles sheet piles pipe piles

PileTips.com
Please contact us for inquiries and quotes
Phone: 503-287-9822 \ 1 (800) 678-0814
Fax: 503-287-7483 \ 1 (800) 287-7483

 

 

 

H-Pile Points

VS300N Series H-Pile Points

Versa Steel H-Pile points are made of high strength, low alloy cast steel. Cast steel is a superior material choice because it's isotropic -- its properties are uniform in all directions. Cast steel points absorb impact and transfer it uniformly to the end of the pile.

Tips are pre-beveled, eliminating pile end preparation. The weld prep is already built into the point; our castings have a 45 degree weld chamfer so there is no need to chamfer piles.

 

H-Pile Points
Weld Procedure
 
1.

2.

3.
4. 		To insure proper seating of the tip, remove all flash
from end of pile and insert tip.
Using a 70xx series rod, make a single pass weld (see table) across each flange on the outside only.
Do not weld web or inside of flanges.
For heavier sections, you may want to use multiple welding passes.

Full weld description available (PDF)
H-Pile Points

 

 

Piling Accessories - Pile Points and Pile Splicers for H-Piles and all.
 (C) 2006 Versa-Steel, Inc. All Rights Reserved.
 Versa-Steel, Inc., 1618 NE First Ave., Portland, OR 97232-1136 
Phone: 1 (800) 678-0814 \ 503-287-9822   Fax: 1 (800) 287-7483 \ 503-287-7483
Email: Bernie@VersaSteel.com